Is the start button on your Mr coffee iced coffee maker start button not working? Try the fixes and advice we offer in this troubleshooting guide.
You expect your coffee maker to begin producing your preferred beverage as soon as the start button is pressed. Right? Most often, the wire is improperly plugged in, the power switch is not turned on, or you have a bad outlet when Mr. Coffee’s iced coffee maker’s start button is not working.
Trust me, No matter how absurd it seems, it happens frequently!
Even if there is no water in the reservoir, it won’t start. In addition, it requires some time to warm up. So yes, a lot might go wrong. I’ll be discussing those problems with you in the hopes that you can resolve them.
Fixing the Start Button on a Mr. Iced Coffee Maker
This is clearly frustrating when you follow the directions, yet it still doesn’t work. It seems like a lot of folks have had this issue.
So let’s discuss the causes of why your mr coffee iced coffee maker instructions won’t turn on or start, along with some solutions:
First, look for obvious issues
As I mentioned at the start, you should verify the basics first. Usually, there is no problem with the Start button, however, there may be somewhere else.
To see if the coffee maker is receiving the required electricity, turn your power switch on and off. If there is no power to the start button, it will never work. Therefore, check the power switch again.
If you want to make sure the coffee maker was getting electricity, try plugging it in someplace else in your house where you are certain it will.
It worked for a lot of people by being plugged into a different outlet!
It might be wise to check the circuit breaker at this time as well. Check to make sure the circuit is on and working normally. If the circuit breaker is switched off, all it needs is a simple reset.
If the power source is sound but the device isn’t functioning, there can be a problem with the plug. If the plug is ok, the coffee maker’s power cable may be faulty.
Despite how boring it may appear, finish the fundamental steps before moving on to the more difficult ones.
The “Brew Now” Button Was Not Pressed by You
I was enraged when I ran into this issue! All is OK, it appears. It was turned on, the power cord was plugged in, and so on. Why did it turn on the “ON light” when I just hit the “Brew Now” button?
I believe that the coffee maker will only turn on while it is brewing. It may not be the case for you, but it’s worth a go!
Not Enough Water In the Reservoir
Yes, Mr. Iced Coffee Maker can detect whether there is enough water in the reservoir to turn it on. As a safety, if the required water level is not there, it won’t switch on.
To check the water, you can but are not required to open the lid. In front of the coffee maker is a gauge to check the water level.
Add some water if there isn’t any, then try the brew again. Additionally, don’t fill up the coffee filter.
Filter Off-Center
For Mr. to drink his coffee, the filter holding it must be balanced. Any coffee maker will work. If it is not centered, it will not function.
So, lift the lid and move the filter once again. Check to see whether the filter appears to be misshaped as well. It must be changed if it is crooked.
Still not functioning?
Now that I think about it, the coffee machine itself has a severe problem. If the outlet has been reset and it is plugged in, but the button does not function, your device is defective.
If it’s still covered by the warranty, I would advise taking it back to the manufacturer or dealer in that situation. You will receive a replacement from them.
You will receive a replacement from them. If your coffee machine is still covered by a warranty, avoid doing the next steps.
If the warranty time has passed, however, you are welcome to research the problems further as stated below:
Mr Coffee iced coffee maker start button not working Dirty and Clogged
When you use water from the tap, it happens to extremely old coffee makers and other similar home goods. Viewed in this manner Minerals in tap water might eventually clog the coffee maker since they are present in it.
It won’t turn on when it’s clogged. Your old coffee machine may be cleaned first by using white vinegar and warm water. With vinegar, you can also wash the filter.
Dry the coffee machine and check to see whether it still functions.
Defective thermostats
The coffee maker won’t start if the thermostat is bad, it’s true. When you’re finished with the above steps I just stated, you need to check this.
The thermostat, which looks like a small white part, is held in place by a metal clip.
If you are skilled, you may test the thermostat terminals using a multimeter.
The coffee maker has an issue with its thermostat if there is no continuity to the terminals. Try not to replace it yourself. To get that fixed, bring it to a nearby repair shop.
Control Board is in bad shape
It does not frequently occur, but there is a potential that the coffee maker’s control board was harmed if Mr. Coffee Maker is too old or there was a major power outage.
Nothing will work at all if the control board in the Mr. Coffee Maker is damaged, not simply the start button.
The control board takes on complex labor during both assembly and reassembly. Thus, if you lack the requisite technical expertise in this area, I would not advise you to replace the control board.
As an option, you might take it to the company’s repair center. They will replace it with a brand-new, original control board, but you must pay.
Last but not least, I found this Mr. Coffee Maker troubleshooting video to be quite helpful in reactivating Mr. Coffee.